Publicidad
Idiomas disponibles
Idiomas disponibles
AUGER
CONTROL
CABLE
ADJUSTMENT
WARNING:
Do not over-tighten,
as this may lift the
lever and cause
the auger
drive
to be engaged
without
depressing
the auger
drive
control,
1. With the auger control lever released, the hook (A, Figure 17)
should barely touch the lever (B) without raising it. There can
be a maximum of 1/32 in. (0.8 mm) clearance.
2. To adjust, loosen the nut (C) by holding the adjusting flats (D)
and turning the nut. Then, turn the adjusting flats and hold
the adjustment screw (E). The adjustment screw is a phillips
screw and the head can be held or turned by inserting a
screwdriver through the spring (F).
3. Hold the adjusting flats and tighten the nut.
4. Start the engine and check the auger. The auger must not be
engaged unless the auger control lever is depressed.
5. With the engine running, fully depress the auger drive control
lever. The auger should engage and run normally.
Adjusting Auger Control Cable
Figure 17
i
,_
WARNING: The auger must stop within 5 seconds. If it I
does not, contact Sears Service.
I
6. Release the auger control lever.
7. If the auger does not operate properly, stop the engine and
recheck the auger control cable adjustment.
8. If the drive linkage is properly adjusted, the tension of the
auger drive belt may require an adjustment. See an authorized
dealer.
CHECK
THE TIRES
Check tires for damage. Check the air pressure in the tires with an
accurate gauge (see Figure 18).
_ll_
CAUTION:
Avoid
Injury!
Explosive
separation
of tire
and rim parts is possible
when they are serviced
incorrectly.
,, Do not attempt
to mount
a tire without the proper
equipment
and experience
to perform
the job.
,, Do not inflate
the tires above
the recommended
pressure,
,, Do not weld or heat a wheel
and tire assembly.
Heat can
cause
an increase
in air pressure
resulting
in an explosion.
Welding
can structurally
weaken
or deform
the wheel.
,, Do not stand
in front
or over the tire assembly
when inflating.
Use appropriate
tool that allows
you to stand
to one side,
NOTICE:
Check
side of tire for maximum
tire pressure.
DO NOT
exceed
maximum,
Checking Tire Air Pressure
Figure 18
(_
21
Publicidad
