Uline H-10193 Manual De Instrucciones página 2

2. Insert backrest post into slot in backrest. Use one
8 x 10 mm backrest post bolt to secure.
(See Figure 2)
NOTE: Install post so side marked "outward" will
face away from seat cushion.
NOTE: Use Allen wrench to tighten bolts.
Figure 2
Backrest Post
3. Align mechanism with holes on bottom of seat
cushion. Use six 6 x 24 mm mechanism bolts
to attach. (See Figure 3)
NOTE: For clearance to tighten bolts, pulling
out seat slider lever and moving mechanism
forward or backward may be necessary.
Figure 3
Mechanism
Seat
PAGE 2 OF 11
ASSEMBLY CONTINUED
6 x 24 mm
Mechanism Bolt
Arm
Bracket
4. Insert armrest into armrest bracket on bottom of seat
cushion and secure using one armrest knob, one
locking washer and one flat washer. Repeat on
opposite side. (See Figure 4)
NOTE: Armrest brackets are pre-attached.
Figure 4
5. Insert backrest post into socket in mechanism on
bottom of seat cushion. Secure using one
10 x 23 mm backrest mechanism bolt. Place cover
over post and use two 4 x 20 mm backrest cover
screws to attach. (See Figure 5)
Figure 5
Backrest
Armrest Adjustment
Knob and Washers
Armrest
Backrest
Mechanism Bolt
Backrest
Cover Screw
1023 IH-10193