Uline H-10193 Manual De Instrucciones página 3

Figure 6
1. Back Angle – To tilt the back, lift the lever and move
freely. To lock tilt position, push lever down while
sitting at preferred angle.
2. Seat/Back Tilt – To adjust seat/back angle, lift lever
up. Chair has standard tilt; the seat and back tilt
simultaneously at the same ratio.
3. Adjustable Tilt Lock – To lock seat/back angle, press
lever down at desired angle.
4. Seat Depth (Seat Slider) – To adjust seat depth, pull
lever out and slide the seat forward or back while
sitting. Release lever to lock in desired position.
5. Seat Height Adjustment – To raise seat height, lift
lever up with little to no weight on the seat. To lower
seat height, lift lever up while sitting.
6. Forward Tilt – To use forward tilt, the back angle
lever (1) must be down, and the seat/back tilt
lever (2) must be up. Once levers 1 and 2 are in
correct position, sit all the way back in the seat, lean
back, pull back on lever (6) and then lean forward.
More force than expected may be required while
leaning back. To stop forward tilt, lean back and
push lever (6) toward the front of chair.
7. Tilt Tension – To increase tilt tension, turn knob
clockwise. To decrease tilt tension, turn knob
counterclockwise.
PAGE 3 OF 11
ASSEMBLY CONTINUED
6. Slowly lower assembled chair, setting mechanism
Completed
Assembly
CHAIR ADJUSTMENTS
8. Back Height Adjustment – To raise back, lift the back
9. Armrest Height Adjustment – To adjust arm height,
1-800-295-5510
uline.com
onto the gas lift. Press down on seat cushion to
secure. (See Figure 6)
IMPORTANT! Forward tilt control may have been
activated during assembly and seat may be
tilted forward. See #6 in "Chair Adjustments" to
deactivate.
until it clicks into the desired height. To lower the
back, lift the seat back to its tallest height to release
ratchet mechanism. Then, push it down to the lowest
height setting.
press the button under the front of each armrest
and move the arm up or down.
6
4
1
5
2,3
8
9
7
1023 IH-10193