Publicidad
Idiomas disponibles
Idiomas disponibles
Line against the hub
Positioning
Tunne_
6. Correctly
installed line will be the
same length on both ends,
CAUTION:
If line is installed incor-
rectly, the cutting head will not function
properly and damage to the unit may
occur.
USER REPLACEABLE
SERVICE
PARTS
REPLACEMENT
PART
Container
of Replacement
Line
Assist Handle
Bolt Carriage. 1/4-20
Wing Nut
Shield Assembly
PART NUMBER
71-85907
530403805
530403886
530016152
530403915
mi, WARNING:
Perform the following
steps after each use.
• Stop the unit and disconnect
the
power source when not in use.
• Carry the unit with motor stopped.
• Store the unit so the line limiter
blade cannot cause injury.
• Store unit and extension
cord in-
doors in a high, dry place out of the
reach of children.
Store unit un-
plugged.
• Store unit with all guards in place,
Position unit so that any sharp ob-
ject cannot accidentally
cause injury.
TROUBLESHOOTING
TABLE
WAR N ING:
Always stop unit and discon nect from the power source before
performing all of the recommended
remedies below except remedies that re-
quire unit to be operating.
TROUBLE
CAUSE
REMEDY
Trimmer head
1. Crowding line against
1. Allow tip of _ineto do the cutting.
stops under a
materialbeing cut.
load or does not
2. Electrical failure.
2. Contact Sears Service (see back
turn when switch
cover).
is pressed.
3. Thrown circuit breaker.
3. Check breaker box.
4. Debris stopping head.
4. Remove debris.
Line breaks
1. Une improperly ro_ed
1. Check line routing.
while cutting,
in head.
2, Incorrect line size
2, Use only 0.080 inch (2 mm) din. line.
3. Dirt build-up on unit.
3. Clean unit,
Une welds onto
1. Une size is incorrect.
1. Use only 0.080 inch (2 mm) din. line.
cutting head.
2, Crowding line against
2. Allow tip of line to do the cutting.
material being cut,
Line usage is
1. Line improperly routed
1. Check line routing.
excessive,
in head.
2. Line size is incorrect.
2, Use only 0.080 inch (2 mm) dia. line.
3. Crowding line against
3. Allow tip of line to do the cutting.
material being cut.
4. Cutting head worn or
4. Contact Sears Service (see back
damaged,
cover).
9
Publicidad
