Makita RF1100 Manual De Instrucciones página 6

These routers accommodate the bits with 1/2" diameter
shank. When using the 1/4" diameter shank bit, replace
the equipped collet chuck with the one for 1/4" diameter
shank bit which is provided as the standard accessory.
To remove the bit, follow the installation procedure in
reverse.
Reinstall the motor unit
Install the motor unit into the base as follows.
1. Open the lock lever.
2. While holding the base, insert the motor unit into
the base aligning the pin with the groove in the
base.
3. Confirm that the pin and the groove are aligning.
Rotate the motor unit clockwise into the base.
4. Close the lock lever.
For equipped with switch-in-handle
For model RD1100 and RD1101 only
Connect the motor unit cord to the outlet in the handle.
003673
1. Wrench
1
2. Router bit
2
003674
1. Pin
1
003675
1. Motor unit cord
1
2. Outlet
2
OPERATION
Set the tool base on the workpiece to be cut without the
bit making any contact. Then turn the tool on and wait
until the bit attains full speed. Move the tool forward over
the workpiece surface, keeping the tool base flush and
advancing smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
1
2
3
1. Workpiece
3. View from the top of the
tool
NOTE:
• Moving the tool forward too fast may cause a poor
quality of cut, or damage to the bit or motor. Moving
the tool forward too slowly may burn and mar the
cut. The proper feed rate will depend on the bit size,
the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece, it is
advisable to make a sample cut on a piece of scrap
lumber. This will show exactly how the cut will look
as well as enable you to check dimensions.
• When using the straight guide, be sure to install it
on the right side in the feed direction. This will help
to keep it flush with the side of the workpiece.
2
1
Straight guide (optional accessory)
6
2
4
4
2. Bit revolving direction
4. Feed direction
001985
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4
003678
001984