Replacing Carbon Brushes - Makita RF1100 Manual De Instrucciones

The straight guide is effectively used for straight cuts
when chamfering or grooving.
To install the straight guide, insert the guide bars into the
holes in the tool base. Adjust the distance between the
bit and the straight guide. At the desired distance, tighten
the hex socket bolts to secure the straight guide in place.
1
2
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
Templet guide (optional accessory)
The templet guide provides a sleeve through which the
bit passes, allowing use of the tool with templet patterns.
To install the templet guide, insert the templet guide in
center hole in the base plate and secure in place with the
lock nut.
1
2
003682
1. Hex socket bolts
2. Guide bar
3. Straight guide
3
003689
003693
1. Lock nut
2. Templet guide
3. Base plate
4. Router bit
3
4
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide slid-
ing along the side of the templet.
1
2
3
4
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.

Replacing carbon brushes

Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
7
003696
6 1. Router bit
2. Base
3. Templet
4. Workpiece
5. Templet guide
6. Lock nut
5
001145
1. Limit mark
1
003703
1. Brush holder
cap
1
2. Screwdriver
2