2LS Tools GEMINI R Manual De Instrucciones página 6

Structure
Control panel of the IR remote control
The button symbols and functions correspond to
the comparable buttons on the control panel of the
GEMINI R, see page 13.
Exception:
"Send" LED display
Briefly lights up when buttons 4, 5 or 12 are
13
Flashes as long as buttons 1, 2, 3 or 6 are
Control panel of the laser receiver
"ON/OFF" button
1
Switches the receiver on and off.
"Acoustic signal" button
2
Switches the acoustic signal quied/loud .
"Detector field sensitivity" button
3
Switches the sensitivity between coarse/fine .
LCD display "Acoustic signal"
4 Lights up corresponding to "acoustic signal
LCD display "Target"
Lights up if the laser line is located precisely at the
5
level of the zero line. In addition, a continuous tone
6
"Coarse sensitivity" LCD display
7
Lights up if the sensitivity is set to "coarse".
"Fine sensitivity" LCD display
8
Lights up if the sensitivity is set to "fine".
LCD display "Lower"
Lights up if the laser line is within the sensor
9
window but below the zero line. A slow, intermittent
tone is also emitted.
LCD Display "Higher"
Lights up if the laser line is within the sensor
10
window but above the zero line. A rapid,
intermittent tone is emitted.
LED display "Battery"
11
Indicates the battery's state of charge.
Operating Instructions GEMINI R Rotating Laser
pressed.
pressed.
quied/loud".
is emitted.
Detector field
13
8
7
9
10
11
2
1
EN
6
5
4
3
6