Descargar Imprimir esta página

Craftsman 358.799400 Manual Del Usuario página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

_1_WARNING:
Perform the follow-
ing steps after each use:
• Stop unit and disconnect from the
power source.
• Allow motor to cool before storing or
transporting.
• Store unit with all guards in place.
Position unit so that any sharp ob ect
cannot accidentally cause injury.
• Store unit unplugged, well out of the
reach of children.
SEASONAL
STORAGE
Prepare unit for storage at the end of
the season or if it will not be used for
30 days or more.
If your blower is to be stored for a peri-
od of time:
• Stop unit and disconnect from the
power source.
• Clean the entire unit before lengthy
storage.
• Open inlet cover and clean any dirt,
grass, or debris that has collected. In-
spect the blower and all tubes. Close
and make sure the cover is latched.
• Clean air vents and air inlet of debris.
• Store your unit and extension cord in a
well ventilated area and covered, if
possible, to prevent dust and dirt accu-
mulation. Do not cover with plastic.
Plastic cannot breathe and may cause
condensation and eventual rust or cor-
rosion.
• Check entire unit for loose screws. Re-
place any damaged, worn, or broken
parts.
TROUBLESHOOTING
TABLE
_k WARNING:
Always stop unit and disconnect from the power source before
performing all of the recommended remedies below except remedies that re-
quire unit to be operating.
SYMPTOM
CAUSE
REMEDY
Unit fails to
1. Switch in the OFF position.
1. Slide switch to ON position.
operate.
2. Extension cord discon-
2. Reconnect extension cord.
nected.
3. Circuit breaker tripped, or
3. Reset circuit breaker or
fuse blown,
fuse.
4. Mechanical failure
4. Contact Sears Service
(see back cover).
Unit
1. Mechanical failure
1. Contact Sears Service
vibrates
(see back cover).
abnormally.
Impeller will
1. Debris in air intake area.
1. Clean unit. Remove any
not turn
debris.
freely.
2. Mechanical failure.
2. Contact Sears Service
(see back cover).
11

Publicidad

loading