Casselin CAPP400L Manual De Instrucciones página 18

Troubleshooting
Fault Potential Failure
The appliance is not The unit is not switched on
working
Plug and/ or lead are damaged
Fuse in the plug has blown
Power supply
The appliance turns Too much ice on the evaporator
on, but the
Condenser blocked with dust
temperature
Doors are not shut properly
is too high/ low
Appliance is located near a heat
source or air flow to the condenser is
being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being
stored in the appliance
Appliance is overloaded
The appliance is Loose nut/ screw
unusually loud
The appliance has not been installed
in a level or stable position
The appliance is The appliance is not properly leveled
leaking water
The discharge outlet is blocked
Movement of water to the drain is
obstructed
The water container is damaged
The drip tray is overflowing
P2M035STD - Ver.1.0
Problem solving action
Check the unit is plugged in correctly
and switched on
Call your agent or qualified technician
Replace the fuse (UK Plug)
Check power supply
Defrost the appliance
Call your agent or qualified technician
Check doors are shut and seals are not
damaged
Move the refrigerator to a more
suitable location
Increase ventilation or move appliance
to a cooler position
Remove any excessive hot foodstuffs
or blockages to the fan
Reduce the amount of food stored in
the appliance
Check and tighten all nuts and screws
Check installation position and change
if necessary
Adjust the screw feet to level the
appliance (if applicable)
Clear the discharge outlet
Clear the floor of the appliance (if
applicable)
Call your agent or qualified Technician
Empty the drip tray (if applicable)
16
GB