KRK Systems Classic Serie Guia De Inicio Rapido página 2

QUICK SETUP
STEP 1
(provided) to the AC inlet socket on the studio monitor and power outlet.
STEP 2
Determine the audio input signal that will be
used with the studio monitors and connect the
audio cable (not included) to the appropriate
input. Typical connections direct to a computer
or DJ gear will use the unbalanced RCA input.
Connection to an audio interface or mixer will
use either a balanced ¼" TRS or XLR input.
Set the volume on the input device (mixer,
audio interface or computer) to minimum level.
The HF and LF LEVEL ADJUST are set at "FLAT"
(factory setting).
STEP 3
Set the POWER switch to 'ON' position. Play
an audio track and slowly bring up the volume on the
input device (mixer, audio interface or computer) to
an acceptable listening level.
Auto-Standby activates after 30 minutes of no activity. The Classic Series monitors will
deactivate standby when it detects an input signal having an amplitude of -50dBu or
greater. In quiet (low listening level) situations, adjust the gain stages by setting the
Volume to '0' or lower and increase the input level of the audio source.
Set the POWER switch to 'OFF.' Connect the AC power cord
Warning: Incorrect AC voltage may damage the studio monitor.
Make sure the AC power outlet matches the studio monitor
(should state 100V~, 110-120V~ or 220-240V~.