Publicidad
Idiomas disponibles
Idiomas disponibles
4.
GAS COOKTOP INSTALLATION INSTRUCTIONS
(For 30° & 36" Models)
Adjust the "LOW" setting for regular surface
burner valves (Figure 10)
5. Adjust the "LOW" setting of the dual burner surface
valve (Figure 10) (some models):
Note: On the dual valve the low setting of each portion
a. Push in and turn control to LITE until burner ignites.
should be adjusted individually.
b. Quickly turn knob to LOWEST
POSITION.
a. Push in and turn knob to LITE then continue to turn
c.
If burner goes out, reset control to OFF.
until only the inner portion of the dual burner stays on.
d. Remove the surface burner control knob.
b. Quickly turn knob to LOWEST
POSITION.
e. Insert a thin-bladed screwdriver into the hollow valve
c.
If burner goes out, reset control to OFF.
stem and
engage
the slotted screw inside. Flame size
d.
Remove
the surface burner control
knob.
.
e. The inner portion of the dual burner flame size
can be increased or decreased with the turn of the
screw. Turn counterclockwise to increase flame size.
Turn clockwise to decrease flame size. Adjust flame
until you can quickly turn knob from LITE to LOWEST
POSITION without extinguishing the flame. Flame
should be as small as possible without going out.
Clockwise
S
Counterclockwise
can be increased or decreased with the turn of the
screw B. Use screw A to adjust the low flame size
of the outer portion of the dual burner. Turn the
screw counterclockwise to increase flame size. Turn
the screw clockwise to decrease flame size. Adjust
flame until you can quickly turn knob from HIGH to
LOWEST
POSITION without extinguishing the flame.
Flame should be as small as possible without going
out.
Note: Air mixture adjustment is not required on surface
burners.
When All Hookups are Complete
Make sure all controls are left in the OFF position.
Make
sure the flow of combustion
and ventilation air to
the cooktop is unobstructed.
Model and Serial Number Location
The serial plate is located on the underside of the
cooktop.
When
ordering parts for or making inquires about your
range, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
of your cooktop.
Your serial plate also tells you the rating of the burners,
the type of fuel and the pressure the cooktop was
adjusted for when it left the factory.
R
I
°
Burner.
Before You Call for Service
Valve
Dual
Read
the Before You Call for Service Checklist and
Burner
Valve
Figure 10
operating instructions in your Use and Care Guide.
It may save you time and expense. The list includes
common
occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to the warranty in your
Use and Care Guide for
our service phone number and address. Please call or
write if you have inquiries about your product and/or
need to order parts.
Note: Air mixture adjustment is not required on surface
burners.
Publicidad
