Publicidad
Idiomas disponibles
Idiomas disponibles
POWER PACK ASSEMBLY INSTRUCTIONS
1. Select location near the outside 120-volt covered GFCI
outlet with cover plate marked for WET LOCATION.
Using mounting template (CC), mark holes for power
pack (G). Must be 20 in. above ground level.
Hardware Used
Mounting template
~l•t::::==~•~l
2. Drill holes using 3/16 in. drill bit (not included).
Install anchors (AA) and Phillips screws (BB),
leaving enough space for the power pack (G).
Hardware Used
Anchors
€1!:::::
u
X
1
x2
Phillips Screws
---•m
x2
3. Hang the power pack (G) on the Phillips screws
(BB) by means of the keyhole slots located on
the back of the power pack (G). Note: Do not
attach power pack (G) to the back of the wall yet.
6
20 in.
_
_,.
Lowes. co m/po rtfol io
Publicidad
