Firmware Version - Netum DS Serie Manual De Instrucciones

Firmware version will be displayed by scanning "$SW#VER".

Firmware Version:

Barcode Programming:
Netum barcode scanners are factory programmed for the most common terminal and
communications settings. If you need to change these settings, programming is
accomplished by scanning the bar codes in this guide. An asterisk (*) next to an
option indicates the default setting.
Important Notes ①
Some command barcodes only work in a particular connection mode.
Pay attention to below symbols when you scanning command barcodes.
Command barcodes only apply to scanner work via Bluetooth.
Command bacodes only apply to scanner work via 2.4G Wireless.
RFID Function
Below instruction only apply for DS8100
Steps on triggering a RFID reading
( 1) Connect reader with your device. Refer to page 4-7 (Connection way)
(2) Setup corresponding keyboard language. Refer to page 8-9 (Keyboard
language)
$SW#VER
-2-