Ecler EDRIVE 600 Manual De Instrucciones página 11

Navigation and Viewing Parameters
Many of the processing elements in each input and output path have features that may be
controlled by the user, such as gain, frequency or limiter threshold. We call these
parameters.
A parameter may be adjusted when it is displayed by turning one of the three-parameter knobs.
Each of the three-parameter knobs is associated with a zone on the display. Adjusting
parameter knob will change the value of the parameter showing in the leftmost zone of the display and
so on. Turn a knob clockwise to increase the value of a parameter, or anti-clockwise to decrease it. The
knobs are velocity-sensitive so turning a knob rapidly will cause the action to 'accelerate', so the value
changes more rapidly.
Navigation
The DSP parameters are organised by channel. The currently selected channel is shown in the
top left hand corner of the display. You can navigate between the channels by pressing
buttons. Pressing the channel buttons will scroll through the channels,
screen. When using a Preset that is stereo linked, the channel selection will reflect this. For example
'1&4' indicates outputs 1 and 4. When navigating onto an output channel, the usage of the output, will be
shown briefly at the top of the screen.
Pressing the edit navigation buttons gives access to the various pages
for each channel. The currently selected page is shown in the bottom left hand corner of the display, this
is omitted on some pages where the function is obvious. The screen shows up to three (normally related)
parameters for a given part of the processing functions on a given channel.
The edit buttons allow you to scroll, in either direction, through the different processing pages for
a given Channel. When you go past the last page, you will be returned to the default page.
The channel buttons allow you to scroll, in either direction, through the input and output channels,
whilst trying to maintain the currently viewed processing block. If the channel you scroll to does not have
the currently viewed processing block, the next one will be shown instead.
Note: When the unit powers-up, the settings will be the same as those when the unit was last switched
off.
adjustable features
the leftmost
the channel
utilities and back to the default
of parameters available
11