Neoss NeoScan 1000 Manual De Instalación Y Funcionamiento página 24

Scanning the upper and lower jaw
To scan a 3D model of the upper and lower jaw, follow these steps:
• Dry the teeth thoroughly before starting an acquisition.
• On the NeoPro interface, select the Upper Jaw
OR
Press the mode button on the scanner to select the upper jaw scan mode
• Place the tip of the scanner on the surface of the tooth to stabilize the scanner and press the Start Scan button.
Wait until a 3D image appears on the 3D model display screen, and then slowly move it along the arch at
0-5mm from the teeth. The image will be automatically scanned and displayed on the 3D model display area.
• Slowly move the tip of the scanner along the occlusal surface to scan the remaining teeth in the arch.
The holes on the 3D model will be displayed in the color specified by the
user. It is recommended to scan these areas until the holes disappear.
• When the occlusal surface scan is complete, scan the lingual or buccal surface of the teeth in the arch.
• When the lingual or buccal scan is completed, scan the opposite side of the arch.
Re-dry the teeth as appropriate throughout the acquisition process.
24 NeoScan 1000 Installation and Operation Manual
acquisition mode
.