Publicidad
Idiomas disponibles
Idiomas disponibles
Theoperation of
any lawn
mower can result in foreign
objects thrown into the
eyes, which can result in
severe eye damage.
Always wear safety glasses or eye
shields while operating your lawn mower
or performing any adjustments or repairs.
We recommend a wide vision safety
mask over spectacles or standard safety
glasses.
HOW TO USEYOUR
LAWN MOWER
ENGINE SPEED
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE ZONE CONTROL
ACAUTION:
Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
DRIVE CONTROL
• Self-propelling is controlled by holding
the operator presence control bar down
to the handle and pushing the drive
control Teverforward until it clicks; then
releasing the lever.
• Forward motion will stop when the
operator presence control bar is
released. To stop forward motion
without stopping engine, release the
operator presence control bar slightly
until the drive control disengages. Hold
operator presence control bar down
against handle to continue mowing
without self-propelling.
• To keep drive control engaged when
turning comers, push down on handle
and lift front wheels off ground while
turning lawn mower.
Drive
control
TO ADJUST CU'I-rlNG HEIGHT
Raise wheels for low cut and lower
wheels for high cut, adjust cutting height
to suit your requirements. Medium
position is best for most lawns.
•
TO change cutting height, squeeze
adjuster lever toward wheel. Move
wheel up or down to suit your require-
ments. Be sure all wheels are in the
same setting.
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also. 9-pesition adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
LowerWheels for High Cut
Plat_Ta_l,
Raise Wheels for LowCut
Lever
TO CONVERT MOWER
Yourlawn mower was shippedreadyto be
used as a mulcher.To convertto begging :
REAR BAGGING
• Uft mar door of the lawn mower and place
the grass catcherframe hooks onto the
doar pivct p_ns.
• To convert to mulching ope_,
remove
grasscatcher and dose rear door.
ACAUTION:
Do not run your lawn mower
without clipping deflector or approved
grass catcher in place, Never attempt to
operate the lawn mower with the rear
door removed or propped open.
Pivot
"
Rear
Grass
catcher
handle
Catcher frame hook
To engage
Ddve control
drive control
disengaged 7
Publicidad
