Publicidad
Idiomas disponibles
Idiomas disponibles
How To Assemble The Handle
1.
2.
3.
Remove the T-knobs
and U-bolts
(Figure 1).
Put the upper handle in the opera-
tor's position.
Install the U-bolts and tighten the
T-knobs.
Note: Make sure that the cable is
not pinched between the upper
and lower handle. Make sure the
cable is routed as shown in
Figure 2.
4.
5.
Attach the auger drive cable to the
auger drive lever (Figure 1).
Remove the T-knob
and bolt on the
upper chute and rotate the upper
chute to the operating position
(Figure 3).
Install the bolt and tighten the
T-knob.
\
Upper
Handle
Cable
igure 2
Upper Chute
_Knob
Figure 3
_" CHECKLIST
Before you operate your new snow
thrower, to ensure that you receive the
best performance and satisfaction from
this quality product, please review the
following checklist:
All assembly instructions
have been
completed.
_" The discharge chute rotates freely.
No remaining loose parts in carton.
While
learning
how to use your
snow
thrower,
pay extra attention
to the fol-
lowing
important
items:
_'
Make sure engine
oil is at proper
lev-
el. Use
a high
quality
detergent
oil
classified
"For Service
SG, SH, S J,
SL, or higher".
_'
Make sure the fuel tank is filled prop-
erly with clean, fresh,
unleaded
gaso-
line with a minimum
of 85 octane.
_'
Become
familiar
with the location
of
all
controls
and
understand
their
function.
_'
Before
starting the engine,
make sure
all controls
operate
correctly.
F 041032C
7
Publicidad
