Descargar Imprimir esta página

Powersmart DB2603 Manual De Instrucciones página 77

Cortadora de hilo sin cable 40v
Ocultar thumbs Ver también para DB2603:

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTION
Turbo button
A function of increase in airflow "turbo", is used only on occasions when leaves and trash is stuck or
when the normal airflow is not sufficient. In most cases, normal airflow is sufficient. An increase in
airflow is used mainly for brief measures.
Switching On/Off
Hold the blower with one hand on the control handle - wrap your
thumb around the handle.
Pull the trigger with your index finger and hold it there. The
blower accelerates and air flows from the nozzle.
To switch off, release the On/Off trigger switch. No air flows from
the nozzle.
Using the Blower
Holding and Controlling the Blower
Hold and control the blower with one hand on the control handle - wrap your thumb around the handle.
Point the nozzle at the ground, walk slowly and steadily forwards.
TEMPERATURE CONTROL /OVERLOAD PROTECTION
When the temperature of battery is too high, and the machine switches off automatically.
Switch the power tool off.
Allow the battery to cool down before continuing to work.
When the power tool is blocked and switches off automatically.
Remove the power tool from the workpiece.
As soon as the blockage is corrected, the tool will continue to work at the set stroke rate.
IMPORTANT CHARGING NOTES
WARNING: Battery packs are shipped in a low charge condition to prevent possible
problems. Therefore, you should charge them before first use.
Use only POWERSMART battery charger (Model#DB2202A)
Charge time is approximately 90 minutes and is dependent upon the type of battery pack.
Make sure the power supply is normal household voltage, 120V, AC only, 60Hz.
Attach the battery pack to the charger by aligning the raised ribs on the battery pack with the grooves
in the charger, then slide the battery pack onto the charger.
Press down on the battery pack to be sure contacts on the battery pack engage properly with contacts
in the charger. Latches should snap into ensure charger is correctly connected.
Do not place the charger in an area of extreme heat or cold. It will work best at normal room
temperature.
The battery pack may become slightly warm to the touch while charging. This is normal and does not
indicate a problem.
The red LEDs will flash while charging.
When the green LEDs is light, this indicates the battery is fully charged.
To remove the battery pack from the charger, depress latches and pull up on the battery pack.
When the battery pack is fully charged, remove it from the charger.
On/Off trigger switch
12
Turbo button
Fig.3

Publicidad

loading