Publicidad
Idiomas disponibles
Idiomas disponibles
AND ADJUST
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Release control bar.
Make sure the blade and all moving parts have completely stopped.
o
Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING
HEIGHT
See "TO ADJUST CUTTING HEIGHT" in the Operation
section of this manual.
DISCHARGE
GUARD
The discharge guard, attached to the dischargeopening of
your lawn mower, is provided to prevent the possibilityof
injury resulting from objects being thrown out of the dis-
charge opening into the operator mowing position, if the
dischargeguard becomes damaged, it shouldbe replaced_
TO REMOVE/REPLACE
DRIVE BELT
(See Fig. 12)
o
Remove drive cover_ Remove belt by pushing down on
gear' case puUey,_
•
Turn lawn mower on its side with carburetor and fuel
cap upo
=
Remove blade.
°
Remove debris shield.
o
Remove belt from engine pulley on crankshaft°
°
lnstaU new belt by reversing above steps,
°
Always use factory approved belt to assure fit and long
life.
DRIVE
COVER
BELT
PRESS
N
LP
FIG. 12
12
Publicidad
