Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION AND ASSEMBLY OF THE
LUMINAIRES
Turn the electricity off at the mains and follow
the instructions given below.
SURFACE VERSIONS
The TRISIO surface-mounted range consists of
luminaires ready for mounting. To fasten the
base of the luminaire to the mounting surface –
using at least two screws or expansion plugs –
follow the instructions given in the figure (fig.1):
remove the covers with the aid of a tool
back-off and remove mounting screws
release the base and use it as drilling template
. ( Caution : for a more secure installation, it is
advisable always to keep the two mounting
points in vertical position; pass the mains cable
via the cable gland as shown in the figure
( Caution : fully tighten the cable gland in order
to prevent the cable from moving). Make the
electrical wiring
(see General Notes) . At the
end of these operations, carry out points " "
and " " in the reverse order and fit the seal
back in correct position.
triSio
TRACK VERSIONS
Fig. 1
The TRISIO track-
mounted range
consists of luminaires
ready for mounting on
the Reggiani 3-circuit
electrified tracks (fig.2).
First
mounting slide from
the
Fasten the slide to the
track, being careful of
the positioning direction
90° with the aid of a tool
screw
;
being careful of the mounting side of the adap-
;
ter
For fastening the luminaire to other types of electrified tracks, proceed to
(fig.3): remove the mounting slide from the luminaire (fig.2 ); unscrew
).
the metal lug from locking cam
lug back on cam
6
Fig. 2
remove
the
luminaire
;
; turn the cam by
; fit the luminaire on the track slide,
(see fig.4).
. Lastly follow the instructions given in the (fig.2).
Fig. 3
; tighten safety
. Turn the cam by 180°
; screw the
Publicidad
