Cameo ZENIT W300 TW Manual De Usuario página 18

Please note: The timer function is suitable for use in master/slave mode via cable and W-DMX
SLAVE MODE CONFIGURATION
Press MODE to access the main menu (--- Menu ---). Using UP and DOWN, select the menu item
Slave (observe arrow) and confirm with ENTER. Connect the slave and the master units (same
model, same software version) with a DMX cable and enable a standalone mode on the master
nit. The slave unit will now follow the master unit. If there is no control signal, the display charac-
ters will flash. Flashing stops as soon as a control signal is present.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
SYSTEM SETTINGS (Settings)
Press MODE to access the main menu (--- Menu ---). Using UP and DOWN, select the menu item
Settings (observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the following submenu items (see table, select with
UP and DOWN, confirm with ENTER, change value or status with UP and DOWN, confirm with
ENTER):
Settings
Wireless W-DMX settings
=
settingss (Wireless DMX)
18
Mode
Slave
On = W-DMX activated
W-DMX On/Off
Off = W-DMX deactivated
Receive = W-DMX module as receiver
Operating Mode
Receive = W-DMX module as sender
G3 = G3 broadcasting standard
Transmitting
Mode
G4S = G4S transmission standard
.
™