Cameo ZENIT W300 TW Manual De Usuario página 19

Wireless = W-DMX settings
settingss (Wireless DMX)
Display
= Display rotation
Reverse
Display
Backlight = Display lighting
Operational
DMX Fail = status with DMX
signal fault
Dimmer
= Dimmer curve
Curve
Constant bright-
Constant ness when fading
Bright- = from cold white
ness to warm white
and vice versa
Dimmer Dimmer res-
=
Response ponse
Calibration of
Calibra-
= warm white and
tion
cold white
Automatic
Autolock = locking of the
controls
Link = pair with W-DMX units. W-DMX
must be activated on all devices and the
pairing must be picked up by a transmitter
Link
(Receive Reset).
Unlink = decoupling of all devices
No = Do not retain transmitter pairing
Receive Reset
Yes = Retain transmitter pairing
Display is rotated by 180° (e.g. for head
On
over heels installation)
Off No rotation of the display
On Permanently on
Deactivation after approximately 1 minute
Off
of inactivity
Hold Last command is retained
Blackout Activates blackout
Full On Spotlight switches to full on
Stand Alone Spotlight switches to standalone mode
Light intensity increases linearly with
Linear
DMX value
Light intensity can be finely adjusted at
Exponential lower DMX values and broadly adjusted at
higher DMX values
Light intensity can be broadly adjusted at
Logarithmic lower DMX values and finely adjusted at
higher DMX values
Light intensity can be finely adjusted at
S-curve lower and higher DMX values and broadly
adjusted at medium DMX values
On Function enabled
Off Function disabled
Light responds abruptly to changes in
LED
DMX value
Light behaves like a halogen spotlight with
Halogen
slight brightness changes
RAW WW and CW with maximum value of 255
Individual colour calibration. Cross-mode
User Calibration brightness setting of WW and CW with
values from 0 – 255
Automatic locking of the controls after
approximately 1 minute of inactivity. Dis-
On play shown upon attempted use: "Locked!"
Unlock: Press and hold UP and DOWN
simultaneously for approx. 5 seconds
19