Publicidad
ENTER
ENTER
+
ENTER
ENTER
3.
Electrical Connection
Start-up EMS 17 / EMS 18
2. Press key 'ENTER'. The final position is stored.
3. Move the guiding device to the desired final position via the
other arrow key. The final position limits the guiding movement
in this direction.
4. Press key 'ENTER'. The final position is stored.
The controller sets the "servo-center position" (SC) automatically
to the center between the two final positions. If necessary this
servo-center position can be displaced in operating mode "S-C" via
the arrow keys.
The adjustment of stroke limitation is completed. The LED of the
key "SETUP" gets extinguished.
Erasing of the final positions can be carried out as follows:
SET UP
1. Press key "MAN" and hold it.
2. Press key "SETUP" in addition.
ENTER
3. Press key "ENTER" three times.
The adjustment of gain for the S-C transducer must be set depend-
ing on the application if necessary.
EKR 1000
EKR 1500
CCD Line Guider
EKR 1000
EKR 1500
CCD Line Guider
Attention! The adjustment of the guiding device is
carried out very slowly!
The settings are not overwritten during basic
setup.
Attention! Do not press any arrow key between
step 1 and 2!
white
29
brown
28
yellow
26
pink
25
grey
24
green
38
green + pink
29
brown + grey
28
blue
26
white
25
red
24
yellow
38
EDV No.: MD.154.01.04
Date:
EMS 17
EMS 18
23.08.11
Page:
2/2
Publicidad
