CARLO GAVAZZI EM511 Manual De Usuario página 22

Screensaver
After 5 minutes have elapsed since a button was pressed the unit will display the home page if the screensaver type is "Home
page" (default setting), or it shall activate the slideshow function (if enabled), which displays the selected pages on a rotating basis.
The pages shown can be selected in UCS (S1 version). By default the pages are: 1 (kWh+ TOT, kW), 3 (KW), 4 (V L-N), 5 (A).
Page filter
The page filter makes it easier to use and browse the measurement pages. When you use the
display the pages you are most interested in, which can be selected through the UCS software (S1 version) or is pre-defined (O1
and M1 version)
Note: to display all the pages without using the UCS software, you can disable the page filter from the SETTINGS MENU
(DISPLAY → PAGES→ ALL). By default, the pages included in the filter are: 1 (kWh+ TOT, kW), 2 (kWh- TOT, kW),3 (KW), 4 (V
L-N), 5 (A), 7 (Hz), 10 (kvarh+ TOT), 11 (kvarh- TOT), 12 (kvar), see "Measurement pages" on page 15.
Restoring the factory settings
Restoring the settings using the RESET menu
From the RESET menu you can restore all the factory settings. At start-up the QUICK SET-UP menu shall be available again.
Notes: meters are not reset.
Offset function
Setting some target values using the total reset function
Using this function you can set a target value, it allows you to satisfy your needs:
to substitute an existent analyzer and maintain the acquired data;
l
to let the device work in parallel with your analyzer.
l
Example: follow the diagram below if you want to set the target values that you find in the table:
Energy meters
22 EM511 - User manual | 30/05/2023 | CARLO GAVAZZI Controls SpA
kWh+
kWh-
kvarh
kvarh-
kvah
button, the unit shall only
Values
100 000.00
200 000.00
300 000.00
200 000.00
200 000.00