Publicidad
Idiomas disponibles
Idiomas disponibles
Fault
Spots on the dishes
Noise
The dishes are not
dry
The light is off
The spray arm does
not rotate smoothly
The upper dish rack
is bent
The door cannot be
closed fully
Water leakage at
front side
D0, D1, D2, D3, D4,
D5, D6, D7, or D8 on
the display
Possible reason and solution
Overload
Do not overload your dishwasher.
Improper placement of tableware.
Please refer to the "Operation" section.
Low water pressure.
The water pressure should be 0.03 lMPa.
Insufficient detergent.
Add the recommended amount of detergent. Please refer to the "Operation"
section.
The rinse aid dispenser is empty.
Refill the rinse aid dispenser.
Hard water is accumulated in the liner.
Remove all tableware and cutlery basket from the dishwasher.
Only dish racks are left in the dishwasher. For the best results, please
take 3 tablespoons (40g) of citric acid powder (available from most grocery
stores or online shops) and out the power in the main washing compartment. If
citric acid powder is unavailable, you may pour about 1 cup (200-300 ml) of
white vinegar into a shallow bowl and put this bowl on the upper dish rack, and
then run the "Machine Care" program without detergent.
A certain level of noise during operation is normal.
Open the detergent cover.
The drainage pump works when draining.
The dishwasher is not levelled.
Adjust the foot.
The spray arm hits the dishes.
Readjust the arrangement of dishes.
Empty the dispenser.
Check and refill the dispenser (if it is empty).
The power supply is not connected.
Connect the power supply.
The spray hole on the spray arm is blocked by food particles.
Clean the spray arm.
Improper adjustment of dish rack.
Please refer to the "Upper dish rack with adjustable height" section.
Improper installation of dish rack.
Push the door handle to close the door properly until you hear a click sound.
The dishwasher is not levelled properly.
Check whether the machine is levelled from side to side and from front to back.
Please refer to the levelling instructions in the "Installation" section.
The wrong detergent is used.
If excessive foaming leads to water leakage, let the foam fade away for 24 hours,
and then clean the interior of dishwasher with milk.
Select the rinse aid level setting mode.
This is not an error code. This code indicates the current rinse aid level. For more
information, please refer to the "Add rinse aid" section.
100
Publicidad
