Publicidad
Idiomas disponibles
Idiomas disponibles
Tips:
•
If the soft water system is not required, this
machine can be used without dishwashing
salt, but the hardness level needs to be set
to H0 so that the corresponding icon will not
be on all the time.
•
In order to achieve a satisfactory washing
effect, this machine needs soft water,
otherwise water stains will remain on the
tableware and inside the dishwasher.
•
If the hardness of tap water exceeds a
certain level, it must be softened, i.e.,
decalcified, by adding dishwashing salt to
the water softener inside the dishwasher.
The amount of salt required is set according
to the hardness of the tap water.
Check the water hardness
1. Check the local water hardness. The water
company can help you check it.
2. Set the softening system level of the
dishwasher according to the hardness level
of water.
Set the soft water system
Adjust the settings according to the hardness
level of the water used in the water supply. The
water softener has 9 adjustment levels, and the
dishwasher has been set to the water hardness
level of H5 when leaving the factory.
1. Ensure that the dishwasher has been turned
off, and press the "Intensive" and "Machine
Care" buttons for 3s to set the program.
2. Press the "Intensive" button. Display the
current setting.
3. Press the "Machine Care" button and set
the expected value. The set value range is
H0 - H8.
4. After completing the required water
softener settings, press the "On/Off" button
to shut down and save the settings.
Add salt
The water softening system needs to be
regenerated so that the product can run
continuously with the same performance. For
this purpose, salt suitable for dishwashers is
used.
CAUTION
The dishwasher's salt chamber must be filled
before starting the washing program. In case of
insufficient salt, the salt icon on the display will
light up unless the hardness level is set to H0.
1. Take out the lower dish rack.
2. Turn the cover of the salt softener counter
clockwise to open it and add softening salt.
After loading the dishwashing salt, the
washing
program
immediately to remove the salt and salt
water around the inner cylinder and
prevent corrosion.
3. If you intend to use the hard water softener
system before using this machine for the
first time, you must use the salt funnel to
add not more than 650g of salt to the salt
chamber of this machine.
4. Fill the salt chamber of this machine with
water only before the first use.
5. Tighten the cover again.
6. Run the rinse program without tableware.
CAUTION
•
Do not pour any detergent into the water
softener to avoid failure.
•
Clean the salt particles around the water
softener cover. Otherwise, the salt solution
may corrode the dishwasher and dishes.
•
Align the cover horizontally and rotate it
clockwise for sealing properly. Loosened
cover may cause the salt solution to leak
from the softener, return to the inner tank
and cause corrosion.
•
After adding dishwashing salt, the washing
program should run without tableware. If
86
must
be
started
Publicidad
