Buffalo CJ558 Manual De Instrucciones página 4

EN
Installation
To install the Pie Warmer:
1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are
thoroughly removed from its surfaces.
2. Take the glass display panel and raise it at an angle into the upper track at the rear of the unit [Fig. 1].
3. Once at the top of the track, position the bottom of the glass above the lower track [Fig. 2].
4. Carefully lower the glass into the bottom track [Fig. 3].
5. Insert the two sliding door panels in the same manner as the display panel. Ensure the handles are
located towards the outside edges of the appliance [Fig. 4].
Operation
Note:
• This appliance is for maintaining temperature only. It is NOT suitable for
cooking products or heating products from cold.
• This appliance is intended to be used for commercial applications, for
example in kitchens of restaurants, canteens, hospitals and in commercial
enterprises such as bakeries, butcheries, etc., but not for continuous mass
production of food.
1. Add water to the water tray.
2. Connect the appliance to the mains power supply and turn on the ON/OFF switch ('I" position).
3. Set the thermostat to the desired temperature.
4. The unit will cycle on and off to maintain the set temperature.
The green indicator light and the interior lamp will turn on when the unit is switched on.
The green indicator light will turn off when the desired temperature has been reached.
Note: The appliance has a maximum temperature setting of 90°C.
4
CJ558-CJ559_ML_A5_v1 20230425.indb 4 CJ558-CJ559_ML_A5_v1 20230425.indb 4 2023/4/25 17:07 2023/4/25 17:07