Konig & Meyer 29670 Instrucciones De Montaje página 7

3.) Mounting the cover
 Wall holder is aligned and firmly screwed to the wall
4.) Mounting the adjusting screw and speaker
5.) Setting the emission direction
 Speaker is firmly screw fixed to the wall bracket
To swivel 3, bring the speaker into the desired position. Make sure that the speaker does not
collide with the wall.
1 Place the two cover halves on the wall
mounting plate and push them together.
NOTE: Make sure that the cover halves
fit neatly into each other. If a cable feed-
through is required, remove one of the
knock-out tabs on the back of the cover.
Screw the M8 lock nut onto the adjusting
screw. Then screw the adjusting screw
into the swivel holder 1 until the boom is
aligned horizontally.
Place the speaker on the wall mount from
above 2 and screw it in place with the
washer and the M6 x 20 mm hexagon
screw from below 3. The supplied wrench
can be used for this purpose. The protec-
tive cap is pressed onto the hexagon
screw. The speaker can be adjusted
lengthwise via the slotted hole. This allows
the distance to the wall to be adjusted.
The adjusting screw 1 can be used to ad
just the inclination 2. To do this, turn the
adjusting screw to set the desired inclina-
tion of the boom and lock the adjusting
screw with the M8 lock nut.
NOTE: To make it easier to turn the adjus-
ting screw, lift the speaker slightly with
your free hand.
This relieves the adjusting screw.