Teac A-H300 Manual Del Usuario página 5

Rear Panel Overview
@Right /Left speaker terminals
@Remote control jacks
These jacks are used for the connection of
the TEAC Mini component system(T-H300, R-
H300, PD-H300) for the purpose of operating
it using the Remote Control unit (RC-613
provided with the A-H300 amplifier) or
system control signals.
@Signal ground terminal
Connect the ground lead of the record
player (turntable) to this terminal.
@AC OUTLET (unswitched)
Plug the AC power cord of the source unit
(CD player, cassette deck, etc.) into this AC
OUTLET.
@dudio signal jacks:
@ MD/TAPE 2 PLAY/REC jacks
These jacks are used for the connection
of the MD player or the second cassette
deck.
Connect the output (LINE OUT) jacks of
the MD player or cassette deck to the
PLAY jacks; the input (LINE IN) jacks of
the MD player or cassette deck to the
REC jacks.
@ TAPE 1 PLAY/REC jacks
Connect the output (LINE OUT) jacks of
the cassette deck (R-H300) to the PLAY
jacks; the input (LINE IN) jacks of the
cassette deck to the REC jacks.
REMOTE CONTROL
© CD input jacks
Connect the output (LINE OUT) jacks of
the CD player (PD-H300) to these jacks.
© TUNER input jacks
Connect the output (LINE OUT) jacks of
the tuner (T-H300) to these jacks.
@ AUX input jacks
Connect the output jacks of the VCR or
other AUXiliary source unit to these
jacks.
@ PHONO input jacks
Connect the output jacks of the record
player (turntable) to these jacks.
Note:
Make sure that you connect the white
pin-plug to the white jacks (left); red pin-
plug to the red jacks (right).
@AC power cord
Plug this AC power cord into an AC wall
socket.
a
MOITAPE >
@ Speaker Connection
Before connecting
© Check the impedance of your speakers,
Connect speaker with an impedance of 8
to 16 ohms.
The amplifier's red speaker terminals are
the ® (positive) terminals and the black
terminals are the © (negative) terminals.
©@The @® side of the speaker cable is
marked to make it distinguishable from
the © side of the cable. Connect this
marked side to the red @ terminal and
the unmarked side to the black terminal.
©@Prepare the speaker cords for
connection by stripping off approximately
lcm or less (no more as this could cause
a short-circuit) of the outer insulation.
How to connect
(1) Twist the wires tightly together so that
they are not straggly.
(2) Turn the terminal cap counterclockwise
to loosen it.
The speaker terminal caps cannot be
fully removed from the base.
(3) Insert the wire into the terminal fully and
turn the terminal cap clockwise to
securely connect it.
(4) Make sure it is fastened firm by pulling
the cord lightly.
ENG