Beamz Pro 150.602 V1.0 Manual Del Usuario página 6

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of 154.077 (BBP W-DMX
transmitter/receiver).
Set BBP W-DMX transmitter and receiver into operation by connecting its power unit to the power input and the mains plug to a mains outlet (100-
240V~, 50/60 Hz). The status indicator shortly flashes red.
Set each fixture to the same DMX frequency. Go to
displayed by colour indication.
As soon as the transmitter receives a DMX signal from the light controller, the status indicator turns red. Shortly thereafter, the status indicators of the
receivers will start flashing green to indicate that the DMX signal is being received. The fixtures can now be controlled via wireless 2.4 GHz DMX signal.
Press off existing modes. Press
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press on the remote controller.
2. Press or to choose between the different auto programs.
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
1. Press on the remote controller.
2. Press or to choose between the different sound programs.
To adjust the strobe speed of the automatic program and the sound active program.
1. Press on the remote controller.
2. Press or to either increase or decrease the speed of the program.
3. Press again to turn off the strobe.
To adjust the speed of the automatic program and the sound active program.
1. Press on the remote controller.
2. Press or to either increase or decrease the speed of the program.
To adjust sound sensitivity for in Sound-Active mode
1. Press on the remote controller.
2. Press or to either increase or decrease sound sensitivity.
1. Select adjust master fixture.
2. Press or to adjust select master value
1 Red
2 Green
3 Yellow
4 Blue
5 Magenta
6 Cyan
7 White
return the last modes.
and select the desired universal, it will be
1 ~ 512
1 ~ 512
1 ~ 512
1 ~ 512
1 ~ 512
1 ~ 512
1 ~ 512