Publicidad
Idiomas disponibles
Idiomas disponibles
1. Press
on the remote controller.
2. Press
or
to adjust preset ID.
3. Press
,
,
,
,
or
3. Press again
,
,
,
,
4. Press
or
to either increase or decrease the percentage of each colour.
Fade mode will enable colour gradiënt.
1. Press
on the remote controller.
2. Press
or
to either increase or decrease the fade time.
To adjust the brightness value of the automatic program, the Sound active program and Manual Mode.
Press digit
to
to change different brightness on the device.
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery contacts prevents
the battery from being discharged during storage. Prior to the first operation remove the foil from the battery support on the rear side of
the remote control. Otherwise operation of the remote control is not possible.
If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of the remote
control press the small bar with the groove to the right (1) and at the same time remove the battery support (2).
For operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the positive pole of
the button cell shows upwards in the support.
The fixture has a s built-in timer function. The fixture can show the pre-programmed preset, colour or chase at certain times and dates.
Adjust the battery turn of level on between 5-10%
Press
-
-
Select
-
Select
, press enter.
-
Select
-
Select percentage between 5 and 10% with the up and down buttons.
-
Press
to confirm.
Set the current date and time
-
Press
-
Select
-
Select
-
Select
, press enter.
-
Select the year with Up/Down buttons, press enter to select the month with Up/Down buttons, press enter to select the day with
Up/Down buttons.
-
Press
to confirm.
-
Select
, press enter.
-
Select the hours with Up/Down buttons, press enter to select the minutes with Up/Down buttons, press enter to select the seconds
with Up/Down buttons.
-
Press
to confirm.
Set automatic turn On time
-
Press
-
Select
-
Select
-
Select
-
Select the hours with Up/Down buttons, press enter to select the minutes with Up/Down buttons, press enter to select the seconds
with Up/Down buttons.
-
Press
to confirm.
Set automatic turn Off time
-
Press
-
Select
-
Select
-
Select
-
Select the hours with Up/Down buttons, press enter to select the Minutes with Up/Down buttons, press enter to select the seconds
with Up/Down buttons.
-
Press
to confirm.
(red, green, blue, white, amber or ultraviolet) to choose your colour.
or
(red, green, blue, white, amber or ultraviolet) to close your colour.
, press enter.
, press enter.
, press enter.
, press enter.
, press enter.
, press enter.
, press enter.
, press enter.
, press enter.
, press enter.
Publicidad
