Helite RACE SUIT AIRBAG_E02 Manual De Instrucciones página 32

32
English
• Switching on the airbag : press the button
3 beeps and a green or pink LED will flash (depending on the activated detection
mode).
• Sleep mode : after 45 seconds of inactivity, the airbag automatically goes into
sleep mode. It wakes up at the slightest movement.
• Switching off the airbag : press the button
3 beeps and the LED will turn off.
d) Change your detection mode : race track or road
1
You can switch the airbag on/off either with the button
card in the hump or with the button
Turn on your airbag (see page 31), press the button
1
A pink LED (race track mode
2 Hold the button
sound every 5 seconds. Release the button and proceed to the next step within
30 seconds.
3 Hold the button
a green LED will alternate, then a series of beeps will sound.
4
At the end of the procedure :
- The LED flashes green
- The LED flashes pink
GOOD TO KNOW
If the LED turns red and a series of short beeps is heard, the mode change has
failed. You took more than 30 seconds between step 2 and 3, in this case repeat
the procedure.
e) Recharging the battery of airbag
The airbag Race Suit must be recharged every week and to check its battery level
before each use.
3
2
sec
AIRBAG TECHNOLOGY
) or a green LED (road mode
or for 3 seconds, the LED will turn blue and a beep will
or again for 3 seconds. During several seconds a pink and
, road mode is activated.
, track mode is activated.
or 3 times quickly, you will hear
or 3 times quickly, you will hear
3
3
sec
AIRBAG TECHNOLOGY
on the remote HMI on the hump.
4
AIRBAG TECHNOLOGY AIRBAG TECHNOLOGY
on the CDU electronic
or 3 times quickly.
) will flash.