Erreka DOLFIN DOS424E Manual Del Instalador página 59

Position the first section of the guide profile (ADO02 or ADO03)
>100
1
Position the following sections
Secure the operator
>100
3
2
1/2 1/2
P153E
>100
P153F
1
P153G

The guide profile is supplied separately. Two models
are available: ADO02 (for gates of up to 4 metres)
and ADO03 (for gates of up to 6 metres).
1 Position the first section of the guide profile (1)
under the mark [M] and secure it to the gate with
two screws (2).
2 Insert the three pins (3) in the profile on the rounded
side, up to half the length.

Since they are not symmetrical, it is important to
insert them using the round side in order to ensure
they do not move.
1 Position the following section, fitting it on the pins.
The two sections should be closely joined.
2 Attach the section to the gate with two screws.
3 Position the following sections in the same way. If
the last section is longer than necessary, cut off the
excess.
1 After positioning the guide profile, firmly secure the
operator to the base using the assembly screws (1).

Distance between the operator and the guide
profile: 5mm.
INSTALLATION
DOLFIN operator for sliding gates
55