Sensepeek SQ200 Guia Del Usuario página 32

Mounting a 3,5mm GND option
1. Align the hole on the 3,5mm GND towards the needle
2. Press and twist on the 3,5mm GND on the metal cylinder
Please be aware of the sharp needle tip!
Mounting a 5mm GND option
1. Hold the GND clip with the open loop against the probe
2. Press the GND clip with the open loop over the metal cylinder
3. Connect your choice of GND connector
Dismounting a 5mm GND option
1. Remove your GND connector
2. Grab the GND clip with a plier (avoid to grab only the thin pin)
3. Pull gently and the clip will detach
32