Publicidad
Idiomas disponibles
Idiomas disponibles
EN
10. Common failures and processing method
please contact our after-sales service if you have any other questions
Questions
Possible Causes
not connected
power is not turned on
treadmill
safety lock drop
don't work
circuit signal system
break
the fuse blew out
the running
insufficient lubrication
belt doesn't
run smoothly
running belt is too tight
running belt too loose
running belt
slipped
running belt is too tight
Error messages on electronic meter and elimination methods
Possible Cause
E01
poor communication
power assault
E02
Non-sensing signal
E03
controller or motor
E04
abnormal
E05
overload protect
system self-check
E06
failed
safety lock drop
E07
abnormal
external disturbance
display
24
Maintenance Methods
put plug to insert socket
Put the power switch
in"ON" position
put the safety lock in
correct position
check the controller input
terminal and signal circuit
replace fuse
add silicone oil lubricant
adjust running belt tightness
adjust running belt tightness
adjust running belt tightness
Maintenance Methods
The signal line is not plugged.
Plug it again
power tube breakdown,
replacement of electronic control
sensing wire is not plugged in
properly. Plug it again correctly
overload, replace controller
or motor
overload,replace contoller
system failure, replace controller
put the safety lock in
correct position
turn off power switch, turn it on
after one minute
11. Product maintenance
1. Lubrication
When the running machine is used for a period of time, it must be
lubricated with special methyl silicone oil.
Advice:
★
1 hour or less per week
★
Less than 3 hours per week
3-6 hours per week
★
More than 6 hours per week lubricate once a month. Do not
lubricate too much. It is not the more lubricants the better.
Remember: Proper lubrication is an important factor in improving
the life of the treadmill.
2. As for the way to check if you need to add lubricant.
Just grab the running belt and touch the middle of the
running belt back with your hands as much as possible.You
don't need to add lubricant if you have silicone on your hand
(a little damp). You have to add lubricant if the pad is dry
and there is no silicone on your hand.
★Steps to add lubricant to the running
plate (as shown in the right picture)
★Stop running and fold the machine.
★Lift the running belt of the underside of
the main body. Put the oil pot as far as
possible into the middle of the running
belt. And spray methyl silicone oil inside of
the running belt and both sides.
★You can make use of the treadmill speed
of 1km/h to evenly lubricate and step on
the running belt from left to right. After a
few minutes, the methyl silicone oil can be
completely absorbed by the running belt.
lubricate once every 6 months
lubricate once every 3 months
lubricate once every 2 months
EN
25
Publicidad
