Vitrifrigo SLIM Serie Manual De Instrucciones página 23

5. INSTALLATION
Place the fridge on a flat and stable surface.
The fridge is equipped with 4 fixing points. Before installation it is necessary to drill the
insulated casing in the points indicated in (Annex 2) We recommend using 3.9x16 screws
(not supplied). To access all the fixing points it is necessary to remove the drawer.
The motor/condensing unit can be positioned up to about 1.5 m from the refrigerator
unit.
Position the unit in such a way as to guarantee adequate ventilation and away from
heat sources. (Annex 3)
Be sure to connect the condensate drain pipe to avoid water stagnation.
After installation, cover the bushings with the caps provided.
ATTENTION Keep the ventilation openings in the compartment where the
compressor unit is housed free from obstructions.
6. DOOR INVERSION
You can reverse the door opening direction by following the steps below.
Door removal
Unscrew the control panel and move it to make the hinge free to move. Then unscrew
the hinge. Finally remove the door. (Annex 4)
Inferior hinge removal
Remove the inferior hinge unscrewing it. The hinge may be different depending on the
model.
Hinges inversion
Unscrew the pin on both hinges and reassemble them
on the opposite side.
Door retainer inversion
Remove the door retainer unscrewing it and, after removing the caps, reassemble it on
the opposite side. (Annex 5)
Door mounting
Secure the lower hinge on the opposite side to the original one, insert the door from
above into the hinge pin. Assemble the upper hinge and reposition the mask in its seat.
ENG
23