Publicidad
Idiomas disponibles
Idiomas disponibles
Taking a Reading
Measurement
1. Press the On/Off Start button.
+ The pressure cuff will automatically be pressur-
iy
ized and a measurement will be taken.
SYSTOLIC
mmHg
DIASTOLIC
mmHg
The entire display will light for approximately
=
71 | 1 second.
| BR ll- | BE ate l yi
+ If there is air left in the pressure cuff, the
a!
pulse/min.
fully lit time will be longer.
SYSTOLIC
_mmA
DIASTOLIC
mmg
=]
The heart mark
Y will blink when
pulse is
ray
detected during pressurization.
(Dm pu
JEO
' J
In the process of pressurization, changes in
pressurization speed and operating sounds
are normal and necessary for the purpose
of measurement during pressurization.
pulse/min
2. When
measurement
has been completed, the
blood pressure and pulse values will be displayed.
ama
TMA DIASTOLIC mig
e Pressure will be automatically released
LIZ
p
DI
œ
from the pressure cuff.
LN
`M | + If the measured value is in the high
Sa
puseimin.
blood pressure region, the values will
blink (for approximately 6 seconds).
(For how to read the blood pressure
display, see p. 16.)
+ The M) mark will blink. (For storing measure-
ment values, see p. 17.)
e The pulse rate value is the beats per minute
calculated based on the pulse rate during
measurement.
—
3. To switch off the blood pressure monitor, press
the On/Off Start button.
e If you forget to switch it off, the blood pres-
sure monitor will switch off automatically after
approximately 5 minutes.
15
Publicidad
