Panasonic EW3109 Instrucciones De Funcionamiento página 18

Storing Measurement Values
This product can store 90 measurement values.
After measurement, press the Memory/Recall button
while the (M mark is blinking.
SYSTOLIC mmHg — =>
= ( da a ( M "al exl
| A Se ( Be 7 m exl
pulse/min.
Storing is completed.
+ Up to 90 measurement values can be stored. When
the memory is full and additional values are stored,
the oldest value in memory will be deleted and the
new value will be stored.
+ If measurements could not be taken properly (the E
mark is shown instead of the blood pressure value),
measurement values cannot be stored.
* However, even if the E mark is shown for the blood
pressure value, the pulse value will still be stored.
la
de 0 ---------
SYSTOLIC mmHg DIASTOLIC mmHg
> H SEI a o
a 1110 be g
pulse/min.
Number of stored data
( To erase all measured values stored in memory:
1. Press the Memory/Recall button. The stored measurement values will
be displayed.
2. Press the same Memory/Recall button again, and hold it pressed until
the measurement values disappear (approximately 3 seconds or more).
* It is not possible to erase single measurement values.
3. The M) mark and Gd will be shown when all data is deleted.
On/Off Start button.
+ If you forget to switch it off, the blood pressure
monitor will switch off automatically after
approximately 5 minutes.
fe To switch off the blood pressure monitor, press the
ii
17