Publicidad
Idiomas disponibles
Idiomas disponibles
BEVEL ADJUSTMENT
Disconnect
battery
pack from tool. The foot
can be adjusted
up to 50 ° by loosening
the
bevel adjustment
knob at the front of the saw.
Align to desired
angle on calibrated
quadrant.
Then tighten bevel adjustment
knob (Fig. 8).
Because
of the increased
amount
of blade
engagement
in the work
and decreased
stability
of the foot, blade binding
may occur.
Keep the saw steady and the foot firmly on the
workpiece.
BEVEL
ADJUSTMENT
KNOB
LINE GUIDE
For a straight 90 ° cut, use left side of notch in
the foot. For 45 ° & 50 ° bevel cuts, use the right
side (Fig. 9). The cutting guide notch will give
an approximate
line of cut. Make sample cuts in
scrap lumber to verify actual line of cut. This will
be helpful because
of the number of different
blade
types
and thicknesses
available.
To
ensure minimum splintering on the good side of
the material to be cut, face the good side down.
90°
45° & 50°
VERTICALCUTS_
[-- BEVELCUTS
SWITCH
To turn tool "ON", squeeze
the trigger switch.
To turn the tool "OFF",
release
the trigger
switch, which is spring
loaded and will return
to the off position automatically.
Your saw
should
be running
at full speed
BEFORE
starting
the cut, and turned off only
AFTER completing
the cut. To increase switch
life, do not turn switch on and off while cutting.
BRAKE
When
the trigger is released
it activates
the
electrical
brake to stop the blade quickly.
This
feature
is especially
useful
when
making
repetitive
cuts.
GENERAL
CUTS
Always
hold the saw handle
with one hand
and the auxiliary
handle
or housing
with the
other.
Always make sure saw foot rests on portion of
work surface that does not drop off.
_
lways
be sure either
hand
does
not interfere
with
the
free movement
of the lower guard.
Maintain
a firm grip and operate
the switch
with a decisive
action.
Never force the saw.
Use light and continuous
pressure.
_
fter completing
a cut and
the
trigger
has
been
released,
be aware
of the necessary
time
it
takes
for the blade
to come
to a complete
stop
during
coast
down.
Do not allow
the
saw
to brush
against
your
leg
or side,
since
the
lower
guard
is retractable,
it
could
catch
on your
clothing
and expose
the blade. Be aware of the necessary
blade
exposures
that exist in both the upper and
lower guard
areas.
When cutting is interrupted,
to resume cutting:
squeeze
the trigger
and allow the blade
to
reach full speed,
re-enter
the cut slowly and
resume cutting.
When
cutting
across
the grain,
the fibers of
the wood
have
a tendency
to tear and lift.
Advancing
the saw
slowly
minimizes
this
effect. For a finished cut, a cross cut blade or
miter blade is recommended.
-12-
Publicidad
