Publicidad
Idiomas disponibles
Idiomas disponibles
EN 26
must never be lifted by rope and tackle. During transport, lower the cut-
ting deck, engage the parking brake and fasten the machine securely to
the hauling device with ropes or chains.
5.7 ADVICE ON HOW TO OBTAIN A GOOD CUT
1. To keep a lawn green and soft with a good appearance, it should be cut regu-
larly without damaging the grass.
2. It is always better to cut the grass when dry.
3. The blade must be in good condition and well sharpened so that the grass is
cut straight without any ragged edge that leads to yellowing at the ends.
4. The engine must run at full speed, both to ensure a sharp cut of the grass
and to get the necessary thrust to push the cuttings through the collector chan-
nel.
5. The frequency of mowing should be in relation to the rate of growth of the
grass, which should not be left to grow too much between one cut and the next.
6. During hot and dry periods, the grass should be cut a little higher to prevent
the ground from drying out.
7. If the grass is very tall, it should be cut twice
in a twenty-four hour period. The first time at
maximum cutting height, possibly reducing the
cutting width and the second cut at the height
desired.
8. The appearance of the lawn will improve if
you alternate the cutting in both directions.
9. If the collector channel tends to get blocked with grass, you should reduce
the forward speed since this may be too high for the condition of the lawn. If the
problem persists, the probable causes are either the badly sharpened blade or
deformed wings.
10. Be very careful when mowing near bushes or kerbs since these could distort
the horizontal position of the cutting deck, and damage its edge as well as the
blade.
HOW TO USE THE MACHINE
1
2
Publicidad
