Genie CB 850 Instrucciones De Uso página 11

Use
First-time use
 Remove all packaging material. Dispose of it immediately.
Setting the paper stop
Perforating
Note:
The edge of the paper stop must lie exactly on the marking of the format selected. Always test the
perforator on a piece of scrap paper before you use it on your real project. This will help you detect
whether the holes are evenly distributed before starting.
 The Perforation mechanism was given a protective layer of coating before being packaged.
Before use, perforate a few pieces of scrap npaper until there is no more residue to be seen.
 It is easier to perforate plastic sheeting if a piece of paper is placed on
either side and all pages are perforated together.
1. Pull the lever of the perforating and binding device fully upwards.
If the lever is not fully raised, the paper cannot be inserted as far as the stop and
will not be perforated.
CAUTION - material damage
• Perforate a maximum of 12 sheets of Standard paper (80 g/sqm) at
once.
• Thin plastic sheets and cardboard (max. 300 g/sqm or 0.2 mm thick)
must be perforated individually.
1. Loosen the screw of the paper stop.
2. Push the paper stop to the required
format.
11