Maintenance Schedule & Daily Check List - Sunrise Medical Oxford Hoyer Arise Manual De Instrucciones Y Garantía Para El Usuario

16
MAINTENANCE SCHEDULE & DAILY CHECK LIST
All Oxford/Hoyer products are designed for minimum maintenance, however some safe-
ty checks and procedures are required. A schedule of DAILY tasks are detailed below.
Daily checks and a six monthly service, inspection and test will ensure a lift is kept in
optimum safe working condition. A list of spare parts is available upon request.
The LOAD TEST and certification should only be carried out by qualified personnel or
an authorised service agent / dealer.
DAILY CHECK LIST: Sunrise Medical strongly recommends the following checks be car-
ried out on a daily basis and before using lift.
• MAKE sure the lift moves freely on its castors.
• EXAMINE the spreader bar (cow horns) is firmly attached to the boom.
• EXAMINE the sling hooks and attachment clips on the spreader bar and boom for
excessive wear.
• MAKE sure the legs open and close correctly.
• OPERATE the hand control to confirm the boom raises and lowers satisfactorily.
• ON electric powered lifts check the operation of the emergency stop button.
• EXAMINE slings for fraying or other damage. DO NOT use any sling if damaged
• CONFIRM the lift is not giving a low battery alarm when the hand control is
operated. If the alarm sounds, DO NOT use and place on charge immediately.
MAINTENANCE, INSPECTION AND TEST
Sunrise Medical recommend a thorough inspection and test of the Oxford/Hoyer Arise
lift and lifting accessories, slings, scales etc is carried out on a regular basis.
Inspection frequency varies from country to country so you must check with your deal-
er or local government agency as appropriate regarding how often an inspection is
required. The examination and test should be conducted according to the recommenda-
tions and procedures below. Sunrise Medical recommends maintenance, inspection and
certified testing is carried out by authorised service agent / dealers only.
NOTE:
These recommendations are in compliance with the requirements of 1998 No2307 Health
and Safety: The Lifting Operations and Lifting Equipment Regulations 1998. This is a UK
regulation. Outside the UK please check your local country requirements.
294000.10008 Rev. C
E n g l i s h E n g l i s h
*THESE CHECKS SHOULD INCLUDE:
1. BOOM: Check the attachment of the boom to the mast. Make sure
there is only minimal side movement of the boom and the boom
is free to rotate on the boom bearing.
2. MAST: Check the operation of the mast-locking device. Make sure
the mast fully engages into the socket. Check the bottom actuator.
3. ACTUATOR: The actuator should require no
maintenance other than checking for correct operation and
listening for unusual noise.
4. POWER PACK: Check the function of the
emergency stop button and emergency lower.
5. BATTERIES: The batteries are housed in the power
pack and should not require maintenance other than the regular
charging as detailed in the charging instructions. Check that the
connections remain clean.
6. LEG ADJUSTMENT: Check the legs operate in both full
extensions (inward/outward).
7. CASTORS: Check all castors for firm attachment to the legs.
Check for free rotation of the castor and the wheels.
8. CLEANING: Clean with ordinary soap and water and/or any hard
surface disinfectant. Harsh chemical cleaners or abrasives should
be avoided as these may damage the surface finish of the lift.
Avoid wetting any of the electrical parts.
9. LOAD TEST: The load test should be carried out in accordance
with the manufacturer's test procedures. It is strongly recommended
the testing is carried out by an authorised service dealer.
10. BASE AND WHEELS: Ensure base is even and level
(all four wheels are on the floor).
11. SLINGS: Check for wear and fraying.
12. LUBRICATION: Oil pivot joints, including mast and boom
connections, pedal assembly, spreader bar joint (only if required
13. HAND SET: Ensure plugged fully into controller.
17
 
 

 

 
 


 


).
 
294000.10008 Rev. C