Publicidad
Idiomas disponibles
Idiomas disponibles
To prevent fire or shock hazard, disconnect your unit from the AC power source when
cleaning.
The glossy finish on the Amplifier unit and Speaker boxes may only be cleaned with the
included Soft Brush and a high quality microfiber lens cleaning cloth (not included) and
cared for as other expensive furniture. Use extra caution when cleaning and wiping the
glossy finished parts. Never use any wax or polish sprays on these parts to avoid causing
permanent damage.
If the VACUUM TUBES on the Amplifier unit and the TWEETER and WOOFER on the
Speaker system becomes dusty, use the Soft Brush (included) to get rid of the dust. Replace
the detachable Speaker Cloth Grille after cleaning.
If you intend to move the Amplifier unit and/or the speaker boxes to a new location, always
try to wear a pair of Soft Cotton Gloves (included) first. Always grip the Amplifier unit by its
side panels and the Speaker box by its bass reflex opening and its base.
Always disconnect all the attached cables from the Amplifier and Speaker units before
relocating them.
Caution: Never allow any water or other liquids to get inside the units while cleaning.
Should you experience difficulties in the use of this system please refer to the following chart or
call 1-800-777-5331 for product service and support.
SYMPTOM
The unit does not
respond (no power).
No sound from the
Speakers
No sound from left or
right Speaker
The sound output is
abnormal (sounds
unnatural or weak
bass output)
CARE AND MAINTAINENCE
TROUBLESHOOTING GUIDE
POSSIBLE PROBLEMS
AC Power Cord is not
plugged into a wall outlet
properly
Wall outlet is not
functioning.
The Line Fuse is burnt out.
The VOLUME CONTROL is
turned fully
counterclockwise (minimum
position).
The connection wires of the
source are not connected
properly to the Amplifier
AUX IN terminals.
The SOURCE SELECTOR
is not set to the correct
signal source.
Speakers are not connected
properly
One or both speakers are
not properly connected.
One or both AUX input is not
properly connected.
The L and R terminals of the
Amplifier AUX IN terminals
and external source outputs
are reversed.
SUGGESTED SOLUTIONS
Plug the AC Power Cord into a working
AC wall outlet securely.
Plug another device into the same outlet
to confirm the outlet is working.
Replace with a 1.6A fuse measured Ø5
x 20mm.
Turn the VOLUME CONTROL
clockwise slowly to increase the
volume.
Make sure the connecting cables are
fully inserted into the jacks on both
ends.
Make sure the SOURCE SELECTOR is
set to the corresponding input signal
source.
Check that the speaker cables are
connected correctly.
Recheck both speaker cables to ensure
they are connected properly.
Recheck the connecting cables
between the Amplifier AUX IN terminals
and your source to ensure they are
correctly and securely connected. Try a
new pair of cables if problem persists.
Remove the connecting cables between
the Amplifier AUX IN terminals and your
external source and re-connect them
correctly and securely.
E-10
Publicidad
