Operation - HotShot HYPH4601-12 Manual De Instrucciones

Step 14
Turn the cylinder valve on the tank clockwise to close
the propane tank� Attach the preassembled regulator to
the cylinder valve by turning the regulator coupling nut
clockwise� Make sure it is fastened securely and tighten
connections by hand only�
WARNING:
Please inspect the rubber O-ring in the propane tank valve
to ensure it is not worn before attaching regulator. Worn
rubber O-rings can cause leaks, explosions and serious injury
by propane tank�
Before performing a leak test, be sure that no sparks can occur, and you are in a spacious outdoor area� Connect
the propane gas tank to the regulator and turn the valve on the unit to the "off" position� Brush a soap and water
mixture on all connections� Turn the gas supply on; if bubbles appear on any connection there may be a leak� If you
smell gas or a leak is discovered turn the gas valve off, disconnect the propane gas tank and do not use the appli-
ance until the leak is repaired�
1� The glass tube may break if it is wet while in use; never use the heater while it's raining outside�
2� Do not splash any liquid on the heater while it is in use�
3� Keep children away from the unit while in use; the glass tube may be extremely hot while in use� Do not touch�
4� Ensure that the heater is on a strong and flat surface� The heater may be damaged if the unit tips over�
5� Never use the heater is the glass tube shows any cracks�
CYLINDER VALVE
BLACK COUPLING NUT
turn clockwise to connect
REGULATOR
RUBBER O-RING
ASSEMBLY INSTRUCTIONS
PRESSURE
RELIEF VALVE
BLEED-OFF
VALVE
turn clockwise
to reseal

OPERATION

14