Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6
Solution suggestions for problems
Drying process takes too much time
•
Meshes of the filter may be clogged. Wash with water.
Laundry come out wet at the end of drying.
•
Meshes of the filter may be clogged. Wash with water.
•
Excessive laundry might have been loaded in. Do not overload the machine.
Machine does not switch on or the program does not start. Machine is not activated when set.
•
It might have not been plugged in. Make sure that the machine is plugged in.
•
The loading door may be ajar. Make sure that the loading door is properly closed.
•
Program might have not been set or the «Start/Pause/Cancel» button might have not been
pressed. Make sure that the program has been set and it is not in "Pause" mode.
•
«Childproof lock» might have been activated. Deactivate the childproof lock.
•
The condenser cover on the models with a condenser might not be closed securely. Make
sure that the condenser cover and the red lock is closed securely.
Program has been interrupted without any cause.
•
The loading door may be ajar. Make sure that the loading door is properly closed.
•
Electricity may be cut off. Press «Start/Pause/Cancel» button to start the program.
•
The condenser cover on the models with a condenser might not be closed securely. Make
sure that the condenser cover and the red lock is closed securely.
Laundry has shrunk, become felted or deteriorated.
•
A program suitable for the laundry type might have not been used. Dry only the laundry
which is suitable for drying in your machine after checking the labels on your clothes.
•
Select a program with suitable low temperature for the laundry type to dry your clothes.
Drum lightning does not come on. (for models equipped with a lamp)
•
The machine might have not been started by using the On/Off button. Make sure that the
machine is On.
•
Bulb may have blown. Call the authorized service to replace the bulb.
•
The condenser cover on the models with a condenser might not be closed securely. Make
sure that the condenser cover and the red lock is closed securely.
2 beeps heard when the buttons are pressed or the program selection knob is turned.
•
Childproof lock» might have been activated. Deactivate the childproof lock.
•
Program selection knob might be turned to an undefined position. Select one of the
defined programs.
"Filter cleaning" light is flashing.
•
Filter might have not been cleaned. Clean the cover filter.
"Final / Anti-creasing" LED is on.
•
Program has come to an end. Turn off the machine and take out the laundry.
3 beeps are heard when you press the Start/Pause/Cancel button
•
The loading door may be ajar. Make sure that the machine is plugged in.
•
Make sure that the condenser cover and the red lock is closed securely.
Also for products equipped with a condenser:
"Water tank" warning LED is flashing.
•
Water may be full.
•
Drain the water in the water tank.
A
Call an authorised service agent if the problem persists.
16 EN
Publicidad
Tabla de contenido
