Publicidad
ENGLISH
the laser.
Installing the robot vacuum cleaner and self-emptying base
1. Place the self-emptying base against a wall and leave a minimum free space of 1.5
metres to the front and 0.5 metre to each side. Fig. 7
2. Plug the self-emptying base to a power socket. Wind and store the remaining cord
to prevent accidents.
3. Hold down the Start/Pause button for 3 seconds.
4. When the light indicator turns on, place the robot vacuum cleaner on the self-
emptying base and make sure the charging terminals on the robot match those of
the charging base. If the light is flashing blue, it means the battery is not completely
charged. To ensure the maximum cleaning time, wait until the light turns into steady
blue, as this will indicate the battery is fully charged and the robot is ready to clean.
Warning
- Take the robot vacuum cleaner to the self-emptying base if the battery is low. The
robot vacuum cleaner may not turn on if the battery is very low.
- The robot vacuum cleaner will automatically turn on when placed on the self-
emptying base.
- The robot vacuum cleaner cannot be turned off during charging.
Installing the mixed tank. Fig. 8
- Open the tank silicone cover, fill the tank with water carefully so water does not
come out. Make sure the silicone clip is properly closed to avoid water from pilling.
Never immerse the tank in water or other liquids.
- Install the mop on the mop bracket.
- To install the tank on the robot vacuum cleaner, follow the direction shown in figure
8 and manually press the tab and push it into the correct position. You will hear a click
when it is properly fixed.
- Install the mop bracket following the direction shown in figure 8.
32
EVVO ROBOT ASPIRADOR R9D LÁSER
Publicidad
