Royal Catering RC-CU20-2 Manual De Instrucciones página 11

3.2. Preparing for use
APPLIANCE LOCATION
The temperature of environment must not be higher than 40°C and the relative humidity should be less than 85%. Ensure
good ventilation in the room in which the device is being used. There should be at least 10 cm distance between each side of
the device and the wall or other objects. The device should always be used when positioned on an even, stable, clean,
fireproof and dry surface, and be out of the reach of children and persons with limited mental and sensory functions.
Position the device such that you always have access to the power plug. The power cord connected to the appliance must be
properly grounded and correspond to the technical details on the product label.
Disassemble the device and all its components and clean them before the first use.
3.3. Device use
1) Open the cover of the machine, and then pull out the filter basket and the percolator tube. Pour the required amount of
water into the tank. You can check the amount of water according to the water level indicator [l]/[number of cups]. Do
not pour hot or warm water into the machine - pour cold water only.
2) First moisten the filter basket. This prevents finely ground coffee from getting inside the unit. To add the correct amount
of ground coffee powder, you can use a regular soup spoon or a measuring cup.
The use of evenly, medium ground coffee is recommended so that the brewed coffee will be tastier.
3) Place the filter basket on the percolator tube. Grasp the upper end of the tube and properly insert the lower end of the
tube into the heating section at the bottom of the unit. (Note: the bottom end of the tube must be correctly placed in
the recess, otherwise the filtering function will fail). Then attach (tighten) the cover of the unit. Connect the power cord
to the power source and turn the power switch ON/OFF.
4) When the "Heating" indicator light illuminates, the unit is operating. When the unit has reached the set temperature
and all the coffee powder has been filtered, the unit will keep the coffee warm. The "Keep Warm" indicator light,
indicating that the unit is keeping warm, will light up and the "Heating" indicator light will go out. Then use the dispenser
tap to pour the coffee.
5) If it is necessary to brew another batch of coffee, the machine and its parts must first be cooled and cleaned. Then
repeat steps 1 to 5 above.
3.4. Cleaning and maintenance
a) Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or replacement of
accessories, or if the device is not being used.
b) Use only non-corrosive cleaners to clean the surface.
c) Use only mild, food-safe detergents to wash the device.
d) After cleaning the device, all parts should be dried completely before using it again.
e) Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
f) Do not spray the device with a water jet or submerge it in water.
g) Do not allow water to get inside the device through vents in the housing of the device.
h) The device must be regularly inspected to check its technical efficiency and spot any damage.
i) Use a soft, damp cloth for cleaning.
j) Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they may damage the
surface material of the appliance.
k) Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or other chemical
substances because it may damage the device.
l) Carefully open the lid or pull out the internal parts to avoid injury.
m) A dishwasher can be used to clean the lid, filter basket, and parts of the percolator tube. To clean the percolator tube,
remove the bottom end of the tube from the heating section. If the percolator tube is clogged by coffee powder, push
the tube through with a thin rod or wooden stick and then rinse with water.
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device recycling and
collection point. Check the symbol on the product, instruction manual and packaging. The plastics used to construct the
device can be recycled in accordance with their markings. By choosing to recycle you are making a significant contribution to
the protection of our environment.
Contact local authorities for information on your local recycling facility.