Steiner Thermal Handheld Manual De Instrucciones página 16

EN
Our company assumes no liability for errors and/or accidents
caused by the fault of the user or a third party when using this
product, nor for property and personal damage caused by incor-
rect evaluations of images.
The purpose of this guide is to give users even more knowledge
about our products so they can enjoy them even more. We make
every effort to ensure that the content of this guide is accurate,
but we cannot guarantee the completeness of the content. As
we are constantly updating and improving our products, we re-
serve the right to change these instructions at any time without
notice.
FCC WARNING
This device can generate or use high-frequency energy. Changes
or modifications to this device may cause harmful interference,
unless the changes are expressly stated in the user manual.
The user may lose the right to operate this device if he makes
unauthorized changes or modifications.
This device meets the requirements of Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device must not cause harmful interference (2) This device
30
must accept any interference received, including interference
that may cause undesired operation.
The device has been rated to meet general RF exposure
requirements. The device can be used without restrictions
under portable exposure conditions.
NOTE: This device has been tested and meets the limits for Class
B digital devices under Part 15 of the FCC Rules. These limits
are designed to provide adequate protection against harmful
interference when installed in residential areas. This device
generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, it may
cause harmful radio communications interference. However,
there is no guarantee that there will be no faults with a particular
installation. If this equipment interferes with radio or television
reception, which can be determined by turning the equipment
on and off, the user should attempt to correct the interference
by taking one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the device and the receiver.
• Plug the device into a power outlet that is not connected to
the receiver circuit.
• Ask the dealer or an experienced radio/TV technician for
help.
• The nominal data can be found on the bottom of the device.
EN
31