Monogram ZISB480DNII Manual Del Propietário página 13

ICE & WATER DISPENSER
ICE STORAGE BIN
To remove:
Lift up the access door to reach the ice cubes. With the
access door closed, support the storage bin at the bottom
while slightly lifting. Pull bin straight out.
Access Door
Ice Storage Bin
Important facts about your ice & water dispenser
• Do not add ice from trays or bags to the storage bin. It
may not crush or dispense well.
• Avoid overfilling glass with ice and use of narrow or
extra-tall glasses. Backed-up ice can jam the chute
is blocking the chute, push it through with a wooden
spoon.
• Beverages and foods should not be quick-chilled in the
ice storage bin. Cans, bottles or food packages in the
storage bin may cause the icemaker or auger to jam.
• To keep dispensed ice from missing the glass, put the
glass close to, but not touching, the dispenser opening.
• Some crushed ice may be dispensed even though you
selected CUBES. This happens occasionally when a few
cubes accidentally get directed to the crusher.
49-1000362 Rev. 1
(on some models)
To replace:
Slide the bin back until the tab on the bin locks into the
slot on the shelf. If the bin does not go all the way back,
remove it and rotate the drive mechanism 1/4 turn. Then
push the bin back again.
Drive
Mechanism
• After crushed ice is dispensed, some water may drip
from the chute as small particles of ice melt.
• Sometimes a mound of ice chips will form on the
door in the ice chute. This condition is normal and
usually occurs when you have dispensed crushed ice
repeatedly. The ice chips will eventually evaporate.
• Dispensed water is not ice cold. For colder water, simply
add crushed ice or cubes before dispensing water.
• The first glass of water dispensed may be warmer than
the following ones. This is normal.
• To eliminate drips on the spill shelf, tilt the glass in
slightly when dispensing water.
Rotate
13