Schneider Airsystems SUM 600-10-60 D Manual De Instrucciones Original página 29

Table of contents - Part 2
2.1 General information ..................
2.2 Symbols ..................................
2.3 Safety instructions .................... 10
2.4 Commissioning ......................... 10
2.5 Operation ................................ 11
2.6 Maintenance............................. 11
2.7 Decommissioning...................... 13
2.8 Troubleshooting ........................ 14
2.9 Spare parts service ................... 15
2.10 Warranty conditions .................. 16
2.11 REACh..................................... 16
The specified illustrations appear at the be-
ginning of the Operating Instructions.
2.2 Symbols
Important: Pay particular attention to these symbols!
Symbol Signal
word
DANGER
WARNING
CAUTION
NOTICE
Safety symbols on the compressor
Symbol Meaning
Read the Instruction Manual
Caution: Hot surface!
Caution: Compressor can restart
automatically!
Caution: Danger of electric shock!
Additional symbols on the compressor
Symbol
1
The symbols depend on the equipment of the compressor
Hazard level
Imminently hazardous situation Death or serious injury
Potentially hazardous situation Death or serious injury
Potentially dangerous situation Minor to moderate injury
Potentially dangerous situation Property damage
Meaning
Switch on/off
Oil-free compressed air
2.1 General information
Observe the safety instructions!
9
Read the Instruction Manual!
9
Document inspections, adjustments and
maintenance work in a maintenance log
book. Specify the name and article number
of the unit when making inquiries. Outside of
Germany, different legal or other require-
ments than those listed here may apply.
Before the unit is used, the Instruction Man-
ual must be read and understood and the
user must receive annual instruction.
Note: Read and memorise part 1 of the in-
struction manual!
Subject to technical modifications. Illustra-
tions may deviate from the original.
Consequences if not avoided
Consequences if not observed
Injury or death of the operator
Property damage
Incorrect operation
Burns when touching the surface
Injury or death of the operator
Injury or death of the operator
1
Symbol
BAM/CPM/SUM/UNM/ZPM
Meaning
Protective motor switch
(external)
Oiled compressed air
GB
II/9